|
Post by ron2n2222 on Aug 22, 2014 12:40:07 GMT -8
Looking for the Motor Specifications, Like voltage range, max current. I what to find a rechargeable battery that work on the motors and work on the STEM. I would use a boost or buck circuit to match the STEM Board.
|
|
jasea
Junior Member
Posts: 53
|
Post by jasea on Aug 23, 2014 10:11:36 GMT -8
Hi ron2n2222, Welcome to the forum. You will find the description of the gearboxes at www.pololu.com/product/114 The motors are rated at 3 - 6 volt, so a single cell Li-ion 18650 at a reasonable capacity could be used for the motor driver.The STEM Board is supposed to be Arduino compatible and so should run on at 6 - 20 volts but the preferred range for a UNO is 7 - 12 V. On another project I used the Tamiya gearbox with the higher voltage motor described on the Pololu page that run at 6 -12V. To power this project I used three 18650 5000 mAh rated cells for the Motors and two Cells at the same rating for the Arduino Nano that I used to control the project. I preferred to use two battery packs rather than a single pack and a voltage regulator, to help to reduce electricial noise from the motors effecting the supply to the Nano board. I hope that this helps you. John
|
|
|
Post by ron2n2222 on Aug 25, 2014 12:15:14 GMT -8
John Thanks for the input on the motors, I am new to Robots and Pi-Bot, where is the best place to buy the 18650 5000 mAH batteries and a good charger? Ron2n2222
|
|
jasea
Junior Member
Posts: 53
|
Post by jasea on Aug 26, 2014 4:33:39 GMT -8
|
|
|
Post by ron2n2222 on Aug 26, 2014 12:44:39 GMT -8
John
Thanks again. Well I am only 5,138 miles from you; I live in North West comer of the United State. I also buy most of my parts from the China. I will look into banggood.com
Thanks
Ron
|
|